Help
cancel
Showing results for 
Search instead for 
Did you mean: 
Ground Controller Lvl 1
Message 1 of 3

Need help updating Ender 3 firmware

I am attempting to update the firmware on my Ender-3 from stock V1.1.3 to V1.1.6. I believe I have successfully installed a boot loader but when I try to upload the firmware update, I get the following error message:

 

Arduino: 1.8.11 (Linux), Board: "Sanguino, ATmega1284 or ATmega1284P (16 MHz)"

 

Sketch uses 125024 bytes (96%) of program storage space. Maximum is 130048 bytes.

Global variables use 4573 bytes (27%) of dynamic memory, leaving 11811 bytes for local variables. Maximum is 16384 bytes.

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00

Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

 

This report would have more information with

"Show verbose output during compilation"

option enabled in File -> Preferences.

 

 

Any help would be greatly appreciated.

2 Replies
Highlighted
Commander Lvl 1
Message 2 of 3

Re: Need help updating Ender 3 firmware

Hey, check out this article. I don't have an Ender-3 so I can't test locally but this seems like it will do the job: https://howchoo.com/g/mge1mdfkzjv/ender-3-bootloader-firmware-update-marlin

 



*Mark helpful posts with Accept as Solution to help other users locate important info. Don't forget to give Kudos for great content!*
Highlighted
Ground Controller Lvl 1
Message 3 of 3

Re: Need help updating Ender 3 firmware

I have same problem ....